TAS Service Installation


Home
TAS Service Installation
Poppet Adjustments
Filling and Bleeding System
Fluids


WARNING:  Automatic setting poppets do not bench test ... do not rotate input shaft more than 1.5 revolutions unless gear is completely installed

Bench rotating the input shaft more than 1.5 revolutions from center position when steering gear is not completely installed in the steering system could make the automatic poppets inoperative when the steering gear is installed.   This would require disassembly of the steering gear to position poppet seat and sleeve assemblies.

NOTE:  Poppets will automatically set when the steering gear is completely installed.  As steering wheel is rotated full left or full right, poppets are set when axle stop contact is made.

Flush and bleed the power steering system AFTER the gear is installed and all steering components are assembled.  Click here to follow flush and bleeding guide.

HOMEindbul2a.gif (311 bytes) REQUEST A CATALOGindbul2a.gif (311 bytes)COMPANY PROFILEindbul2a.gif (311 bytes)PRODUCTSindbul2a.gif (311 bytes)TECHNICAL INFOindbul2a.gif (311 bytes)DISTRIBUTORSindbul2a.gif (311 bytes)TALK TO US

Power Steering Specialists, Inc.
690 Green Crest Drive, Westerville, OH 43081
Phone:800-235-3076 Fax:614-882-7312 
Last revised: September 07, 2005